Passer au contenut Passer au menu de navigationt
Vous ne pouvez passer une commande en ce moment, veuillezNous joindre pour obtenir de l’aide
Spinner
K101997
  • SL-4
  • Contact d’allumage stop
  • À vendre
  • Marché secondaire (nouveau)
Comparer

999999 En stock

Spinner

Poids et dimensions

Poids brut
0.075 Kilogram
Poids net
0.075 Kilogram
Longueur
32.0 Millimeter
Largeur
32.0 Millimeter
Hauteur
59.7 Millimeter

Codes VRMS / Explication

034-002-008 Switch - Stop Lamp
Orifice d'alimentation
1/4-18 NPT 
Frein-filet
No Sealant 
Type de connecteur
1/4 SAE Type 1A Terminal 
Dimension orifice borne
#10-32 UNF-2A (2x) 
Avec écrou de borne
Yes 
Pression de fermeture
3-6 PSI 
Courant nominal
10A (12V) / 5A (24V) 
Matiere du corps
Plastic 
Température de service maximale
200 °F (93 °C) 
Température de service mini. [°C]
-40 °F (-40 °C) 
Mise(s) en garde
Installation torque: 35-50 in-lbs. 

Veuillez accepter la déclaration de protection des données et l’exclusion de responsabilité du téléchargement

Disclaimer

The information contained in documents found on this website is intended for the exclusive use of trained persons within the commercial vehicle industry, and must not be passed on to any third party.

All recommendations regarding products and their servicing or usage are with reference to Knorr-Bremse products and should not be considered applicable to products from other manufacturers.

This information does not purport to be all-inclusive and no responsibility is assumed as a result of its use. We cannot accept any liability nor offer any guarantee regarding data accuracy, completeness or timeliness. The information does not represent any guarantee or ensured characteristics of the Products or Systems described.

No liability can be accepted based on the information, its use, recommendations or advice provided. In no event may we be held liable for any damage or loss except in the case of willful intent or gross negligence on our part, or if any mandatory legal provisions apply.

Any legal disputes arising from the use of this information shall be subject to German law.

Note: If service work is carried out on a vehicle as a result of information taken from a document, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.

This disclaimer is an English translation of a German text, which should be referred to for all legal purposes.