Passer au contenut Passer au menu de navigationt
Vous ne pouvez passer une commande en ce moment, veuillezNous joindre pour obtenir de l’aide
Spinner
K041743
  • Versajust
  • Levier régleur (automatique)
  • À vendre
  • Équipement d'origine
Comparer

999999 En stock

Spinner

Poids et dimensions

Poids brut
2.948 Kilogram
Poids net
2.948 Kilogram
Longueur
108.71 Millimeter
Largeur
51.31 Millimeter
Hauteur
206.25 Millimeter

Codes VRMS / Explication

013-001-149 Slack Adjuster - Automatic, Front Brake
013-002-169 Slack Adjuster - Automatic, Rear Brake
013-017-017 Slack Adjuster - Automatic, Position Not Specified
Product Type
Link Style 
Spline Diameter - Teeth
Ø 1.50 IN - 28 Spline 
Arm Length 1
5.50 IN 
Arm Offset
No Offset 
Arm Bushing(s)
Ø .50 IN (Ø 12.7 MM) 
Inclination Angle (Body Angle)
0° 
Lube Fitting Type
90° Elbow 
Lube Fitting Position
0° 
Couple
20,000 IN LBS 
Température de service maximale
158 °F (70 °C) 
Température de service mini. [°C]
-40 °F (-40 °C) 

Veuillez accepter la déclaration de protection des données et l’exclusion de responsabilité du téléchargement

Disclaimer

The information contained in documents found on this website is intended for the exclusive use of trained persons within the commercial vehicle industry, and must not be passed on to any third party.

All recommendations regarding products and their servicing or usage are with reference to Knorr-Bremse products and should not be considered applicable to products from other manufacturers.

This information does not purport to be all-inclusive and no responsibility is assumed as a result of its use. We cannot accept any liability nor offer any guarantee regarding data accuracy, completeness or timeliness. The information does not represent any guarantee or ensured characteristics of the Products or Systems described.

No liability can be accepted based on the information, its use, recommendations or advice provided. In no event may we be held liable for any damage or loss except in the case of willful intent or gross negligence on our part, or if any mandatory legal provisions apply.

Any legal disputes arising from the use of this information shall be subject to German law.

Note: If service work is carried out on a vehicle as a result of information taken from a document, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.

This disclaimer is an English translation of a German text, which should be referred to for all legal purposes.