Skip to content Skip to navigation menu
You cannot place an order at this time, pleaseContact Us for further assistance
Spinner
5013543
  • ADB22X
  • Hub Assembly
  • For Sale
  • Original Equipment
Compare

999999 In Stock

Spinner

Weights & Dimensions

Gross Weight
37.19 Kilogram
Net Weight
37.19 Kilogram
Length
430.0 Millimeter
Width
364.0 Millimeter
Height
430.0 Millimeter

VMRS Codes / Description

018-004-039 Hub & Rotor Assembly
ABS Tone Ring Included
Yes 
Axle Weight Rating
11,500 LBS 
Bearing Type
Standard, Timken 
Hub Assembly Included
Yes (Hub & Rotor) 
Hub Offset
30.5 MM 
Key Dimension
168.8 MM 
Rotor Diameter
Ø 430 MM 
Rotor Height
138.3 MM 
Rotor Thickness
45.0 MM 
Rotor Type
Conventional (U-Shaped) 
Wheel Stud Standout
94.2 MM 

Knorr-Bremse needs your mandatory email address in order to be able to inform you about updates to this downloaded document in justified cases with regard to our legal liability obligations.

Disclaimer

The information contained in documents found on this website is intended for the exclusive use of trained persons within the commercial vehicle industry, and must not be passed on to any third party.

All recommendations regarding products and their servicing or usage are with reference to Knorr-Bremse products and should not be considered applicable to products from other manufacturers.

This information does not purport to be all-inclusive and no responsibility is assumed as a result of its use. We cannot accept any liability nor offer any guarantee regarding data accuracy, completeness or timeliness. The information does not represent any guarantee or ensured characteristics of the Products or Systems described.

No liability can be accepted based on the information, its use, recommendations or advice provided. In no event may we be held liable for any damage or loss except in the case of willful intent or gross negligence on our part, or if any mandatory legal provisions apply.

Any legal disputes arising from the use of this information shall be subject to German law.

Note: If service work is carried out on a vehicle as a result of information taken from a document, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.

This disclaimer is an English translation of a German text, which should be referred to for all legal purposes.