Skip to content Skip to navigation menu
You cannot place an order at this time, pleaseContact Us for further assistance
Spinner
K028565
  • WS-24
  • Wheel Speed Sensor
  • For Sale (Restricted)
  • Original Equipment
Compare

999999 In Stock

Spinner

Weights & Dimensions

Gross Weight
0.13 Kilogram
Net Weight
0.13 Kilogram
Length
949.0 Millimeter
Width
6.2 Millimeter
Height
6.2 Millimeter

VMRS Codes / Description

013-011-002 Sensor - Wheel Speed
Ingress Protection Rating
IPX9K 
Body Type
90° 
Connector Type
Metri-Pack GT 150 Series 2-Way Sealed Connector (Female) 
Harness Length
949 mm
Convoluted Tubing Included
Yes 
Clamping Sleeve Included
No 
Grommet Included
No 
Grease Included
No 
Maximum Operating Temperature
320 °F (160 °C) 
Minimum Operating Temperature
-40 °F (-40 °C) 

Knorr-Bremse needs your mandatory email address in order to be able to inform you about updates to this downloaded document in justified cases with regard to our legal liability obligations.

Disclaimer

The information contained in documents found on this website is intended for the exclusive use of trained persons within the commercial vehicle industry, and must not be passed on to any third party.

All recommendations regarding products and their servicing or usage are with reference to Knorr-Bremse products and should not be considered applicable to products from other manufacturers.

This information does not purport to be all-inclusive and no responsibility is assumed as a result of its use. We cannot accept any liability nor offer any guarantee regarding data accuracy, completeness or timeliness. The information does not represent any guarantee or ensured characteristics of the Products or Systems described.

No liability can be accepted based on the information, its use, recommendations or advice provided. In no event may we be held liable for any damage or loss except in the case of willful intent or gross negligence on our part, or if any mandatory legal provisions apply.

Any legal disputes arising from the use of this information shall be subject to German law.

Note: If service work is carried out on a vehicle as a result of information taken from a document, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.

This disclaimer is an English translation of a German text, which should be referred to for all legal purposes.