Ir al contenidot Ir al menú de navegaciónt
No puede hacer un pedido en este momento,comuníquese con nosotros para más ayuda
Spinner
K118463
  • TLV-9000
  • Válvula de eje elevable
  • Se vende
  • Posventa (nuevo)
Comparar

999999 En stock

Spinner

Peso y dimensiones

Peso bruto
0.513 Kilogram
Peso neto
0.513 Kilogram
Longitud
166.37 Millimeter
Anchura
39.878 Millimeter
Altura
68.58 Millimeter

Códigos VRMS / descripción

016-014-063 Valve - Quick Exhaust, Lift Axle Control
Montaje
Ø .355 IN (2x) 
Tipo de conector
DIN 72585-A1-2.1 
Boca de alimentación 1 - diaprés de elevador
3/8 PTC 
Boca de alimentación 11 - diaprés de suspensión
3/8 PTC 
Boca de salida 21 - diaprés de suspensión
3/8 PTC (2x) 
Boca de salida 23 - diaprés de elevador
3/8 PTC (2x) 
Boca de escape
Dust Shield 
Voltaje (nominal)
12 Volts 
Presión máxima de funcionamiento
145 PSI 
Temperatura máxima de funcionamiento
176 °F (80 °C) 
Temperatura mínima de funcionamiento [° C]
-40 °F (-40 °C) 
Nota (s) de advertencia
Exhaust port can not be pointed down (toward the road) when installed. 

Acepte el aviso de privacidad y la cláusula de exención de responsabilidades de descarga

Disclaimer

The information contained in documents found on this website is intended for the exclusive use of trained persons within the commercial vehicle industry, and must not be passed on to any third party.

All recommendations regarding products and their servicing or usage are with reference to Knorr-Bremse products and should not be considered applicable to products from other manufacturers.

This information does not purport to be all-inclusive and no responsibility is assumed as a result of its use. We cannot accept any liability nor offer any guarantee regarding data accuracy, completeness or timeliness. The information does not represent any guarantee or ensured characteristics of the Products or Systems described.

No liability can be accepted based on the information, its use, recommendations or advice provided. In no event may we be held liable for any damage or loss except in the case of willful intent or gross negligence on our part, or if any mandatory legal provisions apply.

Any legal disputes arising from the use of this information shall be subject to German law.

Note: If service work is carried out on a vehicle as a result of information taken from a document, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.

This disclaimer is an English translation of a German text, which should be referred to for all legal purposes.