Ir al contenidot Ir al menú de navegaciónt
No puede hacer un pedido en este momento,comuníquese con nosotros para más ayuda
Spinner
5016563
  • ADB22X
  • Buje rotor
  • Se vende
  • Equipo original
Comparar

999999 En stock

Spinner

Peso y dimensiones

Peso bruto
37.19 Kilogram
Peso neto
37.19 Kilogram
Longitud
430.0 Millimeter
Anchura
364.0 Millimeter
Altura
430.0 Millimeter

Códigos VRMS / descripción

018-004-039 Hub & Rotor Assembly
Ensamblaje de buje incluido
Yes (Hub & Rotor) 
Tipo de eje
R (Drive Axle) 
Clasificación de peso del eje
23,000 LBS 
Dimensión clave
168.8 MM 
Desplazamiento del centro
46.0 MM 
Tipo de rodamiento
Standard, Timken 
Sobresaliente del perno de la rueda
79.2 MM 
Anillo de tono ABS incluido
Yes 
Tipo de rotor
Conventional (U-Shaped) 
Diámetro del rotor
Ø 430 MM 
Longitud del rotor
138.3 MM 
Espesor del rotor
45.0 MM 

Acepte el aviso de privacidad y la cláusula de exención de responsabilidades de descarga

Disclaimer

The information contained in documents found on this website is intended for the exclusive use of trained persons within the commercial vehicle industry, and must not be passed on to any third party.

All recommendations regarding products and their servicing or usage are with reference to Knorr-Bremse products and should not be considered applicable to products from other manufacturers.

This information does not purport to be all-inclusive and no responsibility is assumed as a result of its use. We cannot accept any liability nor offer any guarantee regarding data accuracy, completeness or timeliness. The information does not represent any guarantee or ensured characteristics of the Products or Systems described.

No liability can be accepted based on the information, its use, recommendations or advice provided. In no event may we be held liable for any damage or loss except in the case of willful intent or gross negligence on our part, or if any mandatory legal provisions apply.

Any legal disputes arising from the use of this information shall be subject to German law.

Note: If service work is carried out on a vehicle as a result of information taken from a document, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.

This disclaimer is an English translation of a German text, which should be referred to for all legal purposes.